The Calibration Assistant consists of the following elements.
Pull-down menus:
Tool bar with a selection of important buttons:
Tabs with the dialogs for most of the tasks that can be done with the Calibration Assistant:
Furthermore, it provides a status bar at the bottom in which messages are displayed. The status bar also displays the calibration results, that is, if the calibration was successful. Please note that the status bar does not provide a scrolling mechanism; if the displayed message is too long, move the mouse over it, so that a tool tip displaying the full message pops up. Alternatively, if the message is only slightly larger than the status bar, you can also drag the left or right border of the Calibration Assistant window to enlarge it.
Images are displayed in the graphics window of HDevelop.