Display
- Display Image
- It is recommended to set the display mode to Normal unless you wish to make
speed measurements.
Other modes are Volatile (volatile grabbing), and Disabled (grabbing images
without displaying them).
- Output Window
- Specifies the graphics window for the image display (either the active graphics
windows, or a window ID from the list).
Statistics
This area displays statistics for the acquisition time and the frame rate of
all acquired images.
- Ignore first image of live acquisition
- When the first image is acquired in live mode, a certain amount of overhead is
added.
Therefore, it is recommended to check box to increase the accuracy of the
results.
Status Bar
- Show frames per second during live acquisition
- Usually, the number of grabbed images and the acquisition time of the last
image are displayed in the status bar of the window.
Ticking this check box causes the frame rate (frames per second) to be
displayed in live mode.
- Show Min/Mean/Max
- If selected, the image acquisition statistics are also displayed in the status
bar of the window.
This way, you can watch the acquisition statistics in any tab card of
the assistant.